Epson Stylus Photo R340 - Page 85

EPSON Stylus Photo R340/350 Revision A
Disassembly and Assembly Disassembly 85
 Illustration (2)
Figure 2-80. Removing the CD-R Guide Assy. (2)
7. Remove the two screws ( ) that secure the Lower CD-R Guide.
8. Slide the Lower CD-R Guide to release it from the seven tabs ( ) and
remove it.
9. Remove the Compression Spring 5.1 and the Stacker Lock from the Upper
CD-R Guide.
10. Release the connector cable of the Tray/CD-R Sensor from the groove of the
Upper CD-R Guide, and remove the Tray/CD-R Sensor.
C.B.P 3x6 (5-7kgf.cm)
Hooked Tabs
1
2
Lower CD-R Guide
Hooked Tabs
Tray/CD-R Sensor
Groove
Hooked Tabs
Stacker Lock
Compression
Spring 5.1
C A U T I O N
When performing the following steps, be careful not to lose the
parts listed below.
 Tray Sensor Lever
 CD-R Sensor Lever
 Torsion Spring 2.8
 Torsion Spring 4.26
 Reinstalling the Tray/CD-R Sensor
z Set the two positioning holes of the Tray/CD-R Sensor onto
the two guide pins.
Figure 2-81. Reinstalling the Tray/CD-R Sensor
z Route the connector cable of the Tray/CD-R Sensor as
shown in Figure 2-80.
Positioning Holes and Guide Pins