Problems With Paper Feeding 61
■ Colors will change slightly after drying. Wait for 24 hours and check your print again to
see if the colors look right.
■ If you are printing without a computer, check your printer’s control panel settings to
make sure the Filter setting is not set to
Sepia or B&W and that the image adjustment
settings are set to
Standard (see page 22).
Problems With Paper Feeding
Paper doesn’t eject fully or is wrinkled.
■ If the paper doesn’t eject fully, you may have set the wrong paper size. Press the
x Start button to eject the paper, then select the correct paper size.
■ If it’s wrinkled when it ejects, the paper may be damp or too thin.
Paper doesn’t feed correctly or jams in the printer.
■ Make sure the paper support extension is pulled up.
■ If paper doesn’t feed, remove it from the sheet feeder, reload it against the right edge, then
slide the left edge guide against the paper.
■ If multiple pages feed at once, remove the paper from the sheet feeder, fan the edges to
separate the sheets, and carefully reload it.
■ If paper jams, press the x Start button to clear the jam. If that doesn’t clear the paper
jam, open the cover and remove any jammed paper, including small pieces that may have
torn off. Reload the paper and press the
x Start button.
If your paper loads incorrectly or jams frequently:
■ Use new, smooth, high-quality paper, loaded printable side up. Don’t load paper above
the arrow mark on the left edge guide.
■ Place the paper against the right edge and slide the left edge guide against it, but not
too tightly.
■ Store paper flat to prevent curling.
Pbasics.book Page 61 Monday, August 1, 2005 12:31 PM
To Next Page
Loading...
