EPSON Stylus Photo R800 Revision A
PRODUCT DESCRIPTION Functions 13
1.3.6 Error Status
If any of the following states is detected, this printer is put in an error status and
turns the interface signal -ERROR "Low" and BUSY "High" to inhibit data input.
At this time, the printer is automatically disabled from printing. However, when
communication is being made using the IEEE1284.4 protocol, communication
with the printer is enabled.
General error
After the cause of this type of error is removed, the printer can resume its
operation from where it stopped due to the error
Fatal error
After the cause of this type of error is removed, the printer cannot return to
normal unless it is powered off and then on again
Table 1-5. General error
Error Status Occurring Condition Resuming Condition
Paper Mismatch
Error
If the paper path specified by the
print data is different from the
printer's real paper path, the printer
goes to this error.
Change the printer's
paper path to the one
specified by the data.
Paper Out When printer fails to load a sheet, it
goes Paper Out Error.
Set the paper to the ASF
and push the Paper
switch.
Ink Out When the printer runs out the most
part of the ink of any one color, it
warns Ink Low and keeps printing.
When the printer runs out the whole
ink of any one color, it stops printing
and indicates Ink Out Error. User is
requested to install a new Ink-
Cartridge in this state.
Install the new Ink
Cartridge.
No Ink Cartridge/
CSIC Error
When printer detects that Ink
Cartridge comes off, it goes this error
mode.
Install the new Ink
Cartridge.
Paper Jam Error • Failure of ejecting a sheet
• Failure of loading a sheet to the
loading position
Remove the jammed
paper.
Card Loading
Error
When the card was loaded to the
wrong position, the printer goes this
error.
Set an A4 paper to the
ASF, and press the
Paper switch. If the card
couldn't eject at your first
try, repeat again the
same method.
Cutter Jam Error When Cutter can't cut the paper, it
goes Cutter Jam Error.
Switch power off and
recheck the cutter state.
When a paper jam has
occurred, clear the
paper.
Cover Open Error When the cover is opened at
Economy printing mode, the printer
goes this error.
Close the cover.
Table 1-6. Fatal error
Error Status Occurring Condition Resuming Condition
Fatal Error When detecting a Fatal Error such as
a carriage control error, the printer is
placed in an error status.
Turn off and turn on.
Cutter Position
Error
When Cutter can't return to cutter
home position, it goes Cutter Position
Error.
Switch power off and
recheck the cutter state.
When a paper jam has
occurred, clear the
paper.
Maintenance
Request
When the total quantity of ink wasted
through the cleaning and flushing is
reaches to the limit, printer indicates
this error and stops.
Replace the Waste Ink
Pads in the printer
enclosure by a service
person.
Table 1-5. General error
Error Status Occurring Condition Resuming Condition
Download Service Manual And Resetter Printer at http://printer1.blogspot.com
To Next Page
Loading...
