Epson Stylus Photo R800 - Page 63

EPSON Stylus Photo R800 Revision A
TROUBLESHOOTING Overview 64
Dot missing and
mixed colors
(Continued)
[Phenomenon 3]
In the cleaning sequence, ink
is ejected to the Waste Ink
Pads. (This means that the
Pump Unit and Cap Unit
operate properly.) However,
Dot missing is not resolved in
indefinite nozzles after
cleaning has been executed
several times. (Dot missing/
mixed colors)
[Phenomenon 4]
In the cleaning sequence, ink
is ejected to the Waste Ink
Pads. However, drawing
operation is not performed
properly, resulting in mixture
of colors. (Mixed colors)
Ink Cartridge 1. Look at the remaining ink indication of the EPW3 to check
for the ink remaining in the Ink Cartridge.
1. Change the Ink Cartridge for a new one.
Ink System Unit
(Cap Unit)
1. Check that the Cleaner Blade is mounted on the Cleaning
Lever correctly.
1. Change the Cleaner Blade for a new one.
2. Check for foreign matter around the Seal Rubber on the
Cap Unit.
2. Change the Ink System Unit for a new
one.
Table 3-15. Print Quality Fault Check Points
Print Quality State Phenomenon Detail
Faulty Part/
Part Name
Check Point Remedy
Cleaner Blade
Seal Rubbers
Extension Spring 1.19 IS
Download Service Manual And Resetter Printer at http://printer1.blogspot.com