EPSON Stylus PHOTO RX600/610, RX620/630 Revision C
Disassembly and Assembly Main Unit Removal 41
4.2 Main Unit Removal
4.2.1 Panel Unit Removal
1. Remove a USB cable from the Stylus PHOTO RX600/610, RX620/630 unit.
2. Remove the operation panel from the panel unit.
3. Remove two screws securing the panel unit.
4. Remove the panel unit from the printer.
5. Remove three screws that secure front housing.
6. Remove front housing from the printer.
7. Unhook four locations, and remove the decorative panel from the middle housing.
8. Disconnect a panel harness (CN8) to the panel unit from the main board.
9. Remove a the panel unit from the Stylus PHOTO RX600/610, RX620/630 unit.
Figure 4-1. RX600/610 Panel Unit Removal
C.B.P Tite 3x8,F/ZN
Tightening torque:0.6 ± 0.1 N
⋅
m
C.B.P Tite 3x10,F/ZN
Tightening torque:0.6 ± 0.1 N
⋅
m
C.B.P Tite 3x6,F/ZN
Tightening torque
:0.3 ± 0.05 N
⋅
m
Hook
Operation Panel
Panel Unit
Front Housing
Decorative Panel
To Next Page
Loading...
