Epson Stylus Photo RX600 - 1 St Dot Position Adjustment

EPSON Stylus PHOTO RX600/610, RX620/630 Revision C
Adjustment Adjustments by Adjustment Program 70
5.2.2.5 1st Dot Position Adjustment
This adjustment corrects the left margin (Print start position) for post card printing and
A4 printing. The value indicated at the center of the adjustment window is the current
value recorded in EEPROM.
Perform this adjustment in the order of printing the pattern → checking → adjustment
→ printing → checking.
 Media to be used: Normal paper (A4 Size)
 Reference value: 2.0 ~ 4.0 mm (from left edge)
 Functions of buttons
 [Print]: Prints the adjustment pattern.
 [Paper feed]: Use this button when a margin is to be placed above the
pattern printing position.
 [Input]: Select a desired adjustment item and input the
adjustment value, and click the [Input] button to write
the adjustment value in EEPROM.
 [Read]: You can check the current adjustment value.
 [<], [>] : 0.0706 mm (compensation value: 4) shifting
 [<< ], [>> ] : 1.0584 mm (compensation value: 60) shifting
 [  ] : 0.0000 mm (compensation value: 0) shifting
Figure 5-8. 1st Dot Position Adjustment Screen
C H E C K
P O I N T
 For adjustment procedure, click the [How to adjust] button on
the adjustment program screen and see the display.
 After writing the adjustment value in EEPROM, print the
pattern again and check the adjustment value for properness.