1-33
Handling Paper and Other Media | 33
Loading the Paper onto the Spindle
Follow these steps to attach the roll to the spindle:
1. Slide the black paper stop (flange) off the left end of the spindle.
2. Position the roll so the paper unwinds as shown, then slide it onto the
spindle:
3. Slide the movable paper stop back onto the spindle and insert it into the
end of the roll.
Make sure it is firmly fixed into the left end of the paper
roll.
Placing the Paper in the Printer
Follow these steps to place the paper in the printer:
1. Open the roll paper cover.
Note: The spindle
accommodates both
2-inch and 3-inch roll
paper cores. To switch
between different size
cores, see page 37.
Note: Avoid touching the
printable surface of
the paper as much as
possible. Oils from
our skin can affect
print quality.
sp4000Guide.book Page 33 Friday, October 22, 2004 5:06 PM
To Next Page
Loading...
