191
Installing and Using Optional Equipment | 191
5. Secure the manual cutter with the four screws you removed in step 2.
If the cutter has three holes on each side, use the second and third holes
from the top.
If the cutter has two holes on each side, use the lower hole on each side.
Be sure to keep the other two screws.
6. When you are not using the cutter blade, slide it all the way to the left so
it will not damage your printouts.
7. See the manual that came with the Manual Media Cutting System for
instructions on using the cutter.
Removing the Manual Media Cutting System
Be sure to remove the manual cutter when you transport the printer.
1. Remove the screws securing the cutter to the printer.
2. Remove the cutter from the printer.
3. Replace the screws on the printer so you do not lose them.
To Next Page
Loading...
