74
74 | Handling Paper and Other Media
Optimizing the Settings for Your Paper
When you choose a media type in your Epson printer software, the driver
automatically determines the best settings for your paper. However, you may
want to fine-tune how the printer handles various media—especially if you
use non-Epson paper or a paper not supported by the driver. Use the paper
configuration settings described below.
You can create a special configuration, or group of settings, for each paper
type (up to ten types) and select the desired configuration whenever you
print on a particular stock.
Creating Paper Configurations
To create a configuration for a specific paper type, make sure the paper you
want to configure is loaded in the printer. Then follow these steps:
1. Press the
Menu button, then press the d button until CUSTOM
PAPER
is highlighted.
2. Press
Menu to display PAPER NUMBER.
3. Press
Menu, then press the u button to select a paper configuration
number (1 to 10). Press the button to save the number setting.
4. Press the l button, then the d button to highlight
PLATEN GAP. Press
Menu, then press u or d to highlight NARROW, STANDARD, WIDE,
or WIDER
. (The STANDARD setting is recommended for most paper
types.) Press to save the setting.
5. Press the l button, then the d button to highlight
THICKNESS
PATTERN
.
6. Press
Menu, then press to print the paper thickness pattern. A
pattern similar to the following is printed:
Note: Paper
configurations are needed
only for non-Epson media.
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16
Smallest gap
To Next Page
Loading...
