39
Setting Up the Printer | 39
7. If you find that your roll paper is curled too tightly to eject properly,
attach the 5 paper guides to the bottom of the printer. See page 175 for
more information.
Connecting the Power Cord
1. Connect the power cord to the AC inlet on the back of the printer.
2. Route the power cord through one of the hooks on the left or right side
as shown.
3. Plug the power cord into a properly grounded electrical outlet.
Note: The illustrations in
the following sections
show the Epson Stylus
Pro 9880, but the
instructions are the same
for the Pro 7880.
Caution: Do not use an
outlet that is controlled
by an automatic timer or
wall switch. Otherwise,
you may accidentally shut
off the printer and cause
damage.
To Next Page
Loading...
