21
Setting Up the Printer | 21
2. Insert the right leg into the right base as shown. (The bases and legs are
labeled
L and R.) Use the large hex wrench included with the stand to
fasten the leg with the two base bolts.
3. Assemble the left leg and base in the same way.
4. Attach the bottom horizontal strut as shown, then fasten it with one
strut bolt at each end. Make sure the bolts are tight.
Note: Make sure you
tighten all bolts before
moving to the next
section.
Bolt holes
Underside view of base
showing location of bolt holes
To Next Page
Loading...
