EPSON Stylus Pro GS6000 User’s Guide
Handling Paper
35
Setting roll paper
This section explains how to set roll paper.
A
Turn on the printer.
PAPER OUT. LOAD PAPER is displayed on the
LCD panel.
B
Make sure that the Power light is not
flashing, and then raise the paper lever.
LEVER RELEASED is displayed on the LCD
panel.
C
Open the front cover.
D
Set the roll paper to the paper feed slot.
E
Pull the roll paper out about 1 m from the
front paper feed slot which is located inside
of the front cover.
c
Caution:
Do not move the paper lever during
initial operation. The print head portion
may touch the pressurizing roller
portion, and cause a malfunction.
Note:
If the end of the roll paper is not wound tightly,
wind it tightly again, and then load it.
Note:
When loading the new roll paper, cut the front
edge of the paper if it is not straight.
See “Cutting roll paper” on page 44
To Next Page
Loading...
