Epson Stylus NX125/T13/NX130 series Revision F
Disassembly/Assembly Routing FFC/cables 21
Confidential
1.4 Routing FFC/cables
Scanner Unit /CIS (NX125/NX130 series)
When routing the Panel FFC, route it through the ribs (x7) of the Housing, and secure with double-sided tape (x3).
When routing the Scanner FFC, secure it together with the Ferrite Core on the Housing with double-sided tape.
When routing the Scanner Motor cable, pay attention to the following instructions.
• Secure the Ferrite core with the hooks (x2) on the rear of the Scanner Unit.
• Route the Scanner Motor cable through the ribs (x2) and hook (x1) on the rear of the Scanner Unit, and through the hole of the section A and make one
turn around the frame of the section A.
CR Motor
Route the CR Motor cable through the ribs (x10) and make one turn around the rib A.
Route the CR Motor cable so as not to touch the surrounding gears.
Main Board
Connect the following cable to the Main Board as shown in the figure above.
• PF Motor cable
• Power Supply Unit cable
• PF Encoder FFC
• CR Motor cable
• Head FFC
Printhead
Make sure that the Head FFC is connected to the Holder Contact Assy and CR Encoder.
Route the Head FFC through the rib of the Carriage as shown above.
To Next Page
Loading...
Need help?
General
