Epson TM L90 User Manual

TM-L90 User’s Manual 19
English
Troubleshooting
ERROR LED is on or flashing
❏ Make sure that the roll paper cover is closed and the PAPER OUT LED is not on.
Close the cover or replace the paper if necessary.
❏ If the printer has been printing a lot and the print head gets too hot, the ERROR LED
starts flashing, and printing stops. When its temperature cools down to the normal
range, printing resumes automatically.
❏ Turn off the printer and then turn it back on. If the LED is still flashing, consult with
your supervisor or a service person.
PAPER OUT LED is flashing
If the PAPER OUT LED continues to flash even after the issued label is removed, the label
peeler detector may be detecting something. Press the PAPER FEED button once.
Paper jam
Turn off the power, open the peeler cover, and then open the roll paper cover to check for
a paper jam. If there is a paper jam, remove the jammed paper and follow the instructions
in the Installing Roll Paper section to prepare the printer for printing.

Epson TM L90 Specifications

General

Maximum resolution	203 x 203 DPI
Maximum roll diameter	90 mm
Supported paper width	37.5, 79 mm
RS-232 ports	1
Standard interfaces	RS-232
Connectivity technology	Wired
Country of origin	China
Dimensions (WxDxH)	140 x 203 x 148 mm
Flash memory	0.384 MB
Operating temperature (T-T)	5 - 45 °C
Pallet width	800 mm
Pallet height	2600 mm
Pallet length	1200 mm
Pallet width (UK)	1000 mm
Quantity per pallet	112 pc(s)
Quantity per pallet (UK)	168 pc(s)
Quantity per pallet layer	16 pc(s)
Quantity per pallet layer (UK)	24 pc(s)
Package depth	257 mm
Package width	193 mm
Package height	241 mm
Package weight	2560 g
Quantity per pack	1 pc(s)