13
Processing Cut Sheet Paper
Flow of Processing Cut Sheet Paper
From cut sheet paper is inserted until ejected, the product processes it in the following order.
1. Auto sheet feeder (ASF) section: feeds the cut sheet paper.
2. MICR reader section: reads magnetic ink characters on the cut sheet paper.
3. Printer section: prints on the cut sheet paper.
4. Scanner section: scans both sides of the cut sheet paper.
5. Pocket section: ejects the processed cut sheet paper.
Inserting Cut Sheet Paper
You can put up to 100 sheets of cut sheet paper in the ASF.
Note:
Use cut sheet paper (single-ply) that meets the specifications. (See “Specifications” on page 23.)
Do not insert any paper that has clips or staples.
Make sure the cut sheet paper is flat, without curls, folds, or wrinkles.
1. Pull out the ASF guide and the pocket guide appropriately for the size of the cut sheet
paper to be set.
CAUTION:
To avoid a paper jam, always pull out the pocket guide before processing cut sheet paper.
To Next Page
Loading...
Need help?
General
