Epson TM-TM88V-i - Paper Specifications and Cutting

132
Printing and Cutting Positions
Paper Specifications
The values above may vary slightly as a result of paper slack or variations in the paper. Take
this into account when setting the cutting position of the auto-cutter.
80 mm width paper printing 58 mm width paper printing
Paper types Specified thermal paper
Form Roll paper
Size Roll paper diameter 83 mm {3.27"} maximum
Roll paper core Inside: 12 mm {0.47"}, Outside: 18 mm {0.71"}
Roll width when taken
up
80 + 0.5/-1.0 mm 58 + 0.5/-1.0 mm
Paper width 79.5 ± 0.5 mm 57.5 ± 0.5 mm
Specified roll paper type NTP080-80
TRP080-80H
NTP058-80
TRP058-80H
Specified original paper type P300, P310, P350 (Kanzaki Specialty Papers)
AF50KS-E (Jujo Thermal Oy)
F5041 (Mitsubishi HiTec Paper Flensburg GmbH)
KT55F20, KT48F20 (Koehler Paper Group)
 Paper must not be pasted to the roll paper core.
 The remaining amount of the roll paper when a roll paper near-end is detected differs
depending on the core type.
Auto-cutter blade position
Approx. 29 (mm)
Approx. 15 (mm)
Manual-cutter position
Center of the print dotline
Paper feed direction
Printable area
Last line of
a previous receipt