133
Appendix
Electrical Characteristics
AC adapter,RA Input voltage AC 90 V to 264 V (AC 100 V to 240 V)
Output voltage DC 24 V / DC 5 V (2 outputs)
Supply current from
the product
USB 5 V/2.0 A
Maximum supply current of per port: 500 mA
microSD 3.3 V/80 mA
Consumed current (Rating) 24 V/1.8 A, 5 V/2.5 A
Consumed power When operating: 38.7W (230V/50Hz), 38.8W (115V/60Hz)
When standby: 2.8W (230V/50Hz), 2.7W (115V/60Hz)
When off: 0.43W (230V/50Hz), 0.30W (115V/60Hz)
Power supply On/Off Use the power switch on the product
If printing is continuously performed with a high ratio, the overcurrent protection may be acti-
vated and result in uneven print density or a low voltage error. Therefore, the printing length
must not exceed the following values when printing with high print ratio.
Print ratio: Number of dots being energized per one dot line/Total number of dots per one dot
line (512 dots)
Print ratio 80% 100%
Print example
Print length 20 mm 20 mm
To Next Page
Loading...
