33
Chapter 2 Setup
2
Changing the Paper Width
The printer is initially set to print on 80 mm width paper and you can change the printer to print on
58 mm width paper by installing the roll paper guide and changing the paper width setting with the
customized value.
Follow the steps below to install the roll paper guide.
1
Open the roll paper cover.
2
Install the roll paper guide so that the projection on its bottom is aligned
with the hole at the right of the roll paper holder.
3
Tighten the enclosed screw to fix the roll paper guide.
Once you change the paper width from 80 mm to 58 mm, you cannot change it back to 80
mm.
To set the customized value, see "Setting the Memory Switches (Customized Value)" on
page 53.
To Next Page
Loading...
