86
Web Service Settings - Device Admin - Customer Display
You can use this to set communication with the customer display and check its operation.
Item Description
Customer Display Set whether to use the Customer Display.
Communica-
tions settings
Communications
speed (bps)
Set the communication speed.
Usually, not required set.
Data bit Set the data bit length. Usually, not required set.
Parity Set the parity. Usually, not required set.
Brightness settings Set the brightness of the customer display.
You can set 20%, 40%, 60%, or 100%. The maximum bright-ness is
100%.
Test display Performs a test display to the customer display.
Apply Saves settings to TM-T88V-i.
Communication speed and other items must be set for this product in order to control the cus-
tomer display as an RS232C-compliant serial communication device. Set these items to match
the communication conditions of the customer display connected to.
There is no need to install a USB RS232 conversion driver.
If you use the default settings unchanged, there will be no need to alter the communication
settings.
To Next Page
Loading...
