Epson TM-TM88V-i - Connecting the Peripherals; Connecting the Customer Display

40
Connecting the Peripherals
Connect each cable of a peripheral to a port or connector at the rear of the product.
Connecting the Customer Display
Follow the steps below.
1
Put the connection cable of the customer display through the option stand
(DP-110).
CAUTION
 When connecting USB interface devices, make sure to check the devices or man-
uals, etc. for current consumption. The total value should be 2.0 A or less. Never
use devices that provide no information on current consumption.
 Make sure that the protective cover is securely fit into place while the product is
operating.
Option Stand (DP-110)Option Stand (DP-110)
DM-D110DM-D110
DM-D110
Option Stand (DP-110)