Epson TM-TM88V-i - DIP Switch Bank 2 Functions

32
DIP Switch Bank 2
SW Function Function ON OFF
Initial
setting
2-1
Reserved 
(Do not change setting)
Fixed to ON ON
2-2
Reserved 
(Do not change setting)
Fixed to OFF OFF
2-3
Selects print 
density
Standard 2-3: OFF, 2-4: OFF
OFF
Darker than 
standard
2-3: ON, 2-4: OFF
2-4
Dark 2-3: OFF, 2-4: ON
OFF
Forbidden 2-3: ON, 2-4: ON
2-5
Sets the release condition of
the receive buffer BUSY state.
(This function is effective when
DIP Switch 1-2 is set to off.)
Releases the BUSY
state when the
remaining capacity
of the receive buffer
reaches 138 bytes.
Releases the BUSY
state when the
remaining capacity
of the receive buffer
reaches 256 bytes.
OFF
2-6 
2-7
Reserved 
(Do not change settings)
Fixed to OFF OFF
2-8
IF pin 31 reset signal 
(Do not change setting)
Fixed to ON ON
 Do not change the setting of DIP switches 2-1, 2-2, 2-6, 2-7, and 2-8. Otherwise, the
printer may not operate normally.
 Set the print density using the DIP switches when the print density of the customized
value is set to "Depends On Dip Switch" (Initial Settings).
 If the print density is set to “Darker than standard” or “Dark” level, printing speed may be
reduced.