Setting Up the Printer 1–3
2. Two spacers are included. See the illustration below and decide
whether or not you want to use them. Use them if you want the
near-end sensor to be triggered when distance A is 3 to 4 mm;
otherwise it will be triggered when distance A is approximately
6 mm.
3. Secure the paper roll near-end sensor (and spacers) with two
screws. When you insert the spacers, be sure you set the
spacers in the direction shown in the illustration.
4. Check to be sure that detecting lever moves freely.
distance A
Spacers
Paper roll
near-end senso
To Next Page
Loading...
