Epson UB-E04 - Page 25

25
Chapter 2 Set up
2
Security
This is required when using the Wireless LAN unit as well as WPA2™ Enterprise.
SSL/TLS
You can check and set the SSL/TLS.
• Selection of the server certificate type
(Selfsigned Certificate / CA signed Certificate1 / CA signed Certificate2 / CA signed Certificate3)
• Encryption strength setting (Medium / Low / High)
• Setting for automatic redirect from HTTP to HTTPS (Enable / Disable)
• Confirmation of each certificate
Authentication
This is required when using the Wireless LAN unit as well as WPA2™ Enterprise.
Certificate List
You can check and set the following items for self-signed certificates.
• Self-signed certificate setting
• CA signed certificate settings 1 to 3
• CA certificate settings 1 to 10
Certificate Import
You can check and set the following items for certificate imports.
• File format settings (PEM / DER Certification / Password Protection PKCS#12 Certificate)
• File name input
• Password input
* If you import and select an invalid certificate, you will no longer be able to start up EpsonNet Config
(Web version).
In that case, use EpsonNet Config to select a certificate other than the invalid one (for example, a
Selfsigned Certificate), and import the correct certificate with EpsonNet Config (Web version) again.
TCP/IP
IP v4 Address
This sets the IP address when setting the manual.
• Setting for IP address acquisition method (Manual / Auto)
• IP address setting
• Subnet mask address setting
• Default gateway address setting
• APIPA setting (Enable / Disable)
• ARP+Ping setting (Enable / Disable)
DNS/DDNS
This sets the DNS server address (IPv4).
• Setting for automatic acquisition of the DNS server address (Disable / Enable)
• DNS server address setting