201
Related references
Input Signal Settings - Signal Menu
Solutions When Only a Partial Image Appears
If only a partial computer image appears, try the following solutions:
• For VGA connections, press the Auto button on the remote control to optimize the image signal.
• Make sure the Scale setting in the Extended menu is turned off.
• Try adjusting the image position using the Position setting in the Signal menu.
• Press the Aspect button on the remote control to select a different image aspect ratio.
• Check your computer display settings to disable dual display and set the resolution within the
projector's limits. (See your computer manual for details.)
• Check the resolution assigned to your presentation files to see if they are created for a different
resolution than you are projecting in. (See your software help for details.)
• Make sure you selected the correct Projection setting in the Extended menu.
• Try adjusting the image position using the Image Shift setting in the Settings menu.
• If you are projecting in Content Playback mode, make sure you are using the correct Overlay Effect
setting in the Settings menu.
Parent topic: Solving Image or Sound Problems
Related references
Projector Setup Settings - Extended Menu
Input Signal Settings - Signal Menu
Projector Feature Settings - Settings Menu
Related tasks
Changing the Image Aspect Ratio
Solutions When the Image is Not Rectangular
If the projected image is not evenly rectangular, try the following solutions:
• Turn on automatic keystone adjustments using the projector's menus.
• Place the projector directly in front of the center of the screen, facing it squarely, if possible.
• Adjust the image shape using the keystone settings in the projector's menu.
• Adjust the Quick Corner setting to correct the image shape.
To Next Page
Loading...
Need help?
General