EasyManuals Logo

Epson VS210 User Manual

Epson VS210
117 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #114 background imageLoading...
Page #114 background image
You may need to clean the air filter and vent. A clogged air filter or vent can block ventilation needed
to cool the projector. Do not use canned air, or the gases may leave a residue.
Do not store the projector outdoors for an extended length of time.
Except as specifically explained in this manual, do not attempt to service this product yourself. Refer
all servicing to qualified personnel. Opening or removing covers may expose you to dangerous
voltages and other hazards.
Never open any covers on the projector except as specifically explained in this manual. Never attempt
to disassemble or modify the projector. Refer all repairs to qualified service personnel.
Unplug the projector from the wall outlet and refer servicing to qualified service personnel under the
following conditions: if it does not operate normally when you follow the operating instructions, or
exhibits a distinct change in performance; if smoke, strange odors, or strange noises come from the
projector; if the power cord or plug is damaged or frayed; if liquid or foreign objects get inside the
projector, or if it has been exposed to rain or water; if it has been dropped or the housing has been
damaged.
Do not touch the plug during an electrical storm. Otherwise, you may receive an electric shock.
Unplug the projector when it will not be used for extended periods.
Do not use the projector where it may be exposed to rain, water, or excessive humidity.
Do not use the projector where it may be exposed to smoke, corrosive gases, or excessive dust.
Do not use or store the projector or remote control in a hot location, such as near a heater, in direct
sunlight, or in a closed vehicle.
If you use the projector in a country other than where you purchased it, use the correct power cord for
that country.
Do not stand on the projector or place heavy objects on it.
Do not use the projector outside of the required temperature range of 41 to 95 ºF (5 to 35 ºC). Doing
so may cause an unstable display and could lead to projector damage.
Do not store the projector outside of the required temperature range of 14 to 140 ºF (–10 to 60 ºC) or
in direct sunlight for long periods of time. Doing so may cause damage to the case.
Do not place anything that can become warped or damaged by heat near the exhaust vents. Do not
bring your hands or face close to the vents while projection is in progress.
Before you move the projector, make sure its power is turned off, the plug is disconnected from the
outlet, and all cables are disconnected.
Never try to remove the lamp immediately after use because it will be extremely hot. Before removing
the lamp, turn off the power and wait at least an hour to allow the lamp to cool completely.
114

Table of Contents

Other manuals for Epson VS210

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Epson VS210 and is the answer not in the manual?

Epson VS210 Specifications

General IconGeneral
Number of colors16.78 million colors
Projection distance0.87 - 10.5 m
Projection technologyLCD
Contrast ratio (typical)3000:1
Screen size compatibility23 - 350 \
Projector native resolutionSVGA (800x600)
Keystone correction, vertical±30 °
Aspect ratio4:3
RS-232 ports-
Dimensions (WxDxH)294.6 x 228.6 x 78.7 mm
Horizontal resolution560 lines
Connectivity technologyWired
FocusManual
Throw ratio1.45 - 1.96:1
Digital zoom1.35 x
Zoom capabilityYes
Focal length range- mm
Objective focal length16.7 mm
Lamp typeUHE
Lamp power200 W
Lamps quantity1 lamp(s)
Light source typeLamp
Service life of light source4000 h
Service life of light source (economic mode)5000 h
DVI portNo
USB connector typeUSB Type-B
USB 2.0 ports quantityUSB 2.0 ports have a data transmission speed of 480 Mbps, and are backwards compatible with USB 1.1 ports. You can connect all kinds of peripheral devices to them.
S-Video inputs quantity1
Ethernet LAN (RJ-45) ports0
Analog signal format systemNTSC, NTSC 4.43, PAL, PAL 60, PAL M, PAL N, SECAM
Supported graphics resolutions1280 x 960, 1024 x 768 (XGA), 1152 x 864 (XGA+), 1280 x 1024 (SXGA), 1280 x 800 (WXGA), 1400 x 1050 (SXGA+), 1440 x 900 (WXGA+), 640 x 480 (VGA), 800 x 600 (SVGA)
RMS rated power1 W
Product colorBlack, White
Cable lock slot typeKensington
Power sourceAC
AC input voltage100 - 240 V
AC input frequency50 - 60 Hz
Power consumption (standby)- W
Power consumption (typical)283 W
Power consumption (PowerSave)234 W
Noise level37 dB
Noise level (economic mode)29 dB
Operating temperature (T-T)5 - 35 °C
Cables includedVGA
Weight and Dimensions IconWeight and Dimensions
Depth228.6 mm
Width294.6 mm
Height78.7 mm
Weight2300 g

Related product manuals