Epson WF-2110 Series - Control Panel Buttons and Functions

Buttons and Functions
A
Turns the printer on or o.
Unplug the power cord after checking that the power light is o.
B
When a network error occurs, pressing this button cancels the error. Hold this button down for more than ve
seconds to perform Wi-Fi auto setup using the WPS push button.
C
Prints a network connection report allowing you to determine the causes of any problems you may have using the
printer on a network. If you need more detailed network settings and connection status, hold this button down for
at least
ve
seconds to print a network status sheet.
D
Stops the current operation.
Hold this button down for ve seconds until the
P button ashes to run print head cleaning.
When the
H light turns on, press this button to replace the ink cartridges. When the H light
ashes
or turns
o,
hold this button down for 10 seconds until the ink cartridge holder starts moving to replace the cartridge.
Functions using Button Combinations
+
Wi-Fi Direct (Simple AP) Setup
Hold down the
and buttons simultaneously to start Wi-Fi Direct (Simple AP) Setup.
+
PIN Code Setup (WPS)
Hold down the
and buttons simultaneously to start PIN Code Setup (WPS).
+
Restore Default Network Settings
Turn the printer on while holding down the
button to restore the default network
settings. When the network settings are restored, the printer turns on and the network status
lights ash alternately.
+
Disable Network Service
Turn the printer on while holding down the
button to disable Epson Connect settings.
+
Print Nozzle Check Pattern
Turn the printer on while holding down the
button to print the nozzle check pattern.
Guide to the Control Panel > Buttons and Functions
19