7. Confirm the displayed network settings and press Proceed to save them.
Note: If you need to change a setting, press the back button.
8. If you want to print a network setup report, press one of the buttons. (Otherwise, press the
Stop/Reset button.)
9. Press the home button to exit.
The WiFi light should now be on, but not flashing.
Note: If the WiFi light is off, you may have selected the wrong network name or entered the
password incorrectly. Repeat these steps to try again.
Parent topic: Wi-Fi Networking
Enabling Wi-Fi Direct Mode
You can enable Wi-Fi Direct mode to allow direct communication between your product and computer or
other devices without a wireless router or access point.
Note: If the printer is already connected to a wireless router or access point, you must disable Wi-Fi on
the printer before you can use Wi-Fi Direct.
1. Press the home button, if necessary.
2. Select Wi-Fi Setup.
You see this screen:
31
To Next Page
Loading...
