Replacing Ink Cartridges
25
6. Remove the yellow tape from the bottom of the ink cartridge.
Caution: Do not remove any other labels or seals, or ink will leak. Do not touch the
green chip on the front of the cartridge. This can damage the ink cartridge.
7. Insert the new ink cartridge into the holder and push it down until it clicks into place.
8. Once you replace all the cartridges that need replacing, close the cartridge cover and
push it down until it clicks into place.
9. Close the scanner.
10. Press
OK
to begin charging the ink. This takes about 2 1/2 minutes. When you see a
completion message on the LCD screen, ink charging is finished.
Note: Never turn off the product while ink is charging or you’ll waste ink. If you see
an ink replacement message on the LCD screen, press
OK
and press down all the
cartridges securely. Then press
OK
again. If you remove a low or expended ink
cartridge, you cannot reinstall and use the cartridge.
andes_p2_QG.book Page 25 Wednesday, May 25, 2011 3:39 PM
To Next Page
Loading...
