EasyManuals Logo

Epson WorkForce 600 Series Network Installation Guide

Epson WorkForce 600 Series
40 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #3 background imageLoading...
Page #3 background image
Wireless Network Installation 3
Wireless Network Installation
To add the printer to your wireless network, you need to know the name (SSID)
of your wireless network. If it has security enabled, you also need to know the
WEP key or passphrase. Write down the SSID and WEP key or passphrase below:
Network name (SSID): _________________________________________
WEP key or passphrase: _________________________________________
Note:
If the WEP key is either 5 or 13 characters, it’s ASCII. If the WEP key is either 10 or 26
characters, it’s hexadecimal. The default WEP key is usually 1.
If your passphrase contains upper- or lowercase letters, be sure to note it correctly.
The printer supports the following wireless security modes: WEP 64, WEP 128, and
WPA-PSK.
If you don’t know your wireless network name (SSID) or WEP key or passphrase,
contact the person who set up your wireless network before you begin.
Connect the Ethernet Cable
Note:
This is a temporary connection used to configure the printer. You will be prompted to
remove the cable when configuration is complete.
1. Connect an Ethernet network cable to the LAN (10/100) port on your printer.

Other manuals for Epson WorkForce 600 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Epson WorkForce 600 Series and is the answer not in the manual?

Epson WorkForce 600 Series Specifications

General IconGeneral
BrandEpson
ModelWorkForce 600 Series
CategoryAll in One Printer
LanguageEnglish

Related product manuals