Epson WorkForce Pro WF-4720 series - Making Wi-Fi Settings by Push Button Setup (WPS)

7. When you have setup nished, tap Start Setup.
8. Tap OK to nish.
Note:
If you fail to connect, load A4 size plain paper, and then tap Print Check Report to print a connection report.
9. Tap Close on the network connection settings screen.
Related Information
& “Entering Characters” on page 20
& “Checking the Network Connection Status” on page 32
& “When You Cannot Make Network Settings” on page 180
Making Wi-Fi Settings by Push Button Setup (WPS)
You can automatically set up a Wi-Fi network by pressing a button on the access point. If the following conditions
are met, you can set up by using this method.
❏ e access point is compatible with WPS (Wi-Fi Protected Setup).
❏ e current Wi-Fi connection was established by pressing a button on the access point.
Note:
If you cannot nd the button or you are setting up using the soware, see the documentation provided with the access point.
1. Tap on the home screen.
2. Tap the Wi-Fi(Recommended) icon or the Router icon.
3. Tap Start Setup.
If the network connection is already set up, the connection details are displayed. Tap Change to Wi-Fi
connection. or Change Settings to change the settings.
4. Tap Push Button Setup(WPS).
5. Hold down the [WPS] button on the access point until the security light ashes.
User's Guide
Network Settings
28