Epson WorkForce Pro WF-4720 series - Changing the Network Connection to Ethernet from the Control Panel; Disabling Wi-Fi from the Control Panel; Disconnecting Wi-Fi Direct (Simple AP) Connection from the Control Panel

Changing the Network Connection to Ethernet from
the Control Panel
Follow the steps below to change the network connection to Ethernet from Wi-Fi using the control panel.
1. Tap Settings on the home screen.
2. Tap General Settings > Network Settings > Wi r e d L A N S e tu p .
3.
Check the message, and then tap Start Setup.
4. Check the message, and then tap OK.
e screen automatically closes aer a specic length of time if you do not tap OK.
5. Connect the printer to a router using an Ethernet cable.
Disabling Wi-Fi from the Control Panel
When Wi-Fi is disabled, the Wi-Fi connection is disconnected.
1. Tap
on the home screen.
2. Tap the Wi-Fi(Recommended) icon.
e
network status is displayed.
3. Tap Change Settings.
4. Tap Others > Disable Wi-Fi.
5. Check the message, and then tap Start Setup.
6. When a completion message is displayed, tap Close.
e screen automatically closes aer a specic length of time if you do not tap Close.
Disconnecting Wi-Fi Direct (Simple AP) Connection
from the Control Panel
Note:
When Wi-Fi Direct (Simple AP) connection disabled, all computers and smart devices connected to the printer in Wi-Fi
Direct (Simple AP) connection are disconnected. If you want to disconnect a specic device, disconnect from the device
instead of the printer.
1. Tap on the home screen.
User's Guide
Network Settings
40