Epson XP-15000 Series - Changing the Network Connection to Ethernet from the Control Panel; Disabling Wi-Fi from the Control Panel; Disconnecting Wi-Fi Direct (Simple AP) Connection from the Control Panel

Changing the Network Connection to Ethernet from
the Control Panel
Follow the steps below to change the network connection to Ethernet from Wi-Fi using the control panel.
1. Select Settings on the home screen.
To select an item, move the focus to the item using the
u d l r buttons, and then press the OK button.
2. Select Network Settings > Wi r e d L A N S e t u p.
3. Press the OK button.
4.
Connect the printer to a router using an Ethernet cable.
Disabling Wi-Fi from the Control Panel
When Wi-Fi is disabled, the Wi-Fi connection is disconnected.
1. Select Wi - F i on the home screen.
To select an item, move the focus to the item using the
u d l r buttons, and then press the OK button.
2. Select Wi-Fi (Recommended).
e network status is displayed.
3. Select Change Settings.
4. Select Others > Disable Wi-Fi.
5.
Check the message, and then press the OK button.
6. When a completion message is displayed, press the OK button.
e
screen automatically closes
aer
a
specic
length of time.
7. Press the
button.
Disconnecting Wi-Fi Direct (Simple AP) Connection
from the Control Panel
Note:
When Wi-Fi Direct (Simple AP) connection disabled, all computers and smart devices connected to the printer in Wi-Fi
Direct (Simple AP) connection are disconnected. If you want to disconnect a specic device, disconnect from the device
instead of the printer.
1. Select Wi - F i on the home screen.
To select an item, move the focus to the item using the
u d l r buttons, and then press the OK button.
User's Guide
Network Settings
39