Related Information
& “Aligning the Print Head” on page 66
Copy Quality Is Poor
Check the following if uneven colors, smears, dots, or straight lines appear in the copied image.
❏ Clean the paper path.
❏ Clean the scanner glass.
❏ Do not press too hard on the original or the document cover when you are placing the originals on the scanner
glass. Uneven colors, smears, or dots may appear when the original or the document cover is pressed too hard.
❏ If a moiré (cross-hatch) pattern appears, place the original at a slightly dierent angle.
Related Information
& “Cleaning the Paper Path” on page 66
& “Cleaning the Scanner Glass” on page 67
& “Print Quality is Poor” on page 89
Banding Appears on the Copied Image
If you hold down the or button for more than three seconds, the printer copies in dra mode and
banding may appear on the printout.
An Image of the Reverse Side of the Original Appears in the Copied
Image
For a thin original, place the original on the scanner glass and then place a piece of black paper over it.
The Position, Size, or Margins of the Printout Are Incorrect
❏ Load paper in the correct direction, and slide the edge guides against the edges of the paper.
❏ When placing the originals on the scanner glass, align the corner of the original with the corner indicated by a
symbol on the frame of the scanner glass. If the edges of the copy are cropped
o,
move the original slightly
away from the corner.
❏ When placing the originals on the scanner glass, clean the scanner glass and the document cover. If there is dust
or stains on the glass, the copy area may extend to include the dust or stains, resulting in the wrong copying
position or small images.
❏ Select the appropriate paper size setting.
❏ Adjust the margin setting in the application so that it falls within the printable area.
Related Information
& “Loading Paper in the Rear Paper Feed” on page 18
& “Placing Originals on the Scanner Glass” on page 22
& “Cleaning the Scanner Glass” on page 67
User's Guide
Solving Problems
91
To Next Page
Loading...
Need help?
General
