4.
Moisten a cotton swab with the water with a few drops of detergent so that it is not dripping water, and then
wipe the smeared part.
c
Important:
Wipe o the smear gently. If you press the cotton swab too hard to the lm, the springs of the lm may be
dislocated and the printer may be damaged.
5.
Use a new dry cotton swab to wipe the lm.
c
Important:
Do not leave any
bers
on the
lm.
Note:
To prevent the smear from spreading, frequently replace the cotton swab with a new one.
6.
Repeat steps 4 and 5 until the lm is not smeared.
7.
Visually check that the
lm
is not smeared.
Maintaining the Printer
>
Cleaning the Translucent Film
147
To Next Page
Loading...
