Equinox Systems Fusion 150 - Page 8

www.prolight.co.uk Fusion 150 User Manual
8
Slave mode:
Toaccessslavemodepress“MODE”untilthedisplayshowsSLnd.Pressthe“ENTER”button,theunit
shouldnowdisplaySL 1.Usethe“UP”and“DOWN”buttonstoselecteitherSL 1orSL 2.Press
the“ENTER” buttonagain,thiswillenableyourchosenslavemode.
Toexitoutofanyoftheaboveoptions,pressthe“MODE”button.
Adjusting the sound sensitivity:
Toaccessthesoundsensitivitymenupress“MODE”untilthedisplayshowsSoUn.Pressthe“ENTER”
button,theunitshouldnowdisplaythesensitivityinthreedigits.Usethe“UP”and“DOWN”buttonsto
select001through100.Pressthe“ENTER” buttonagain,thiswillsetthesoundsensitivity.
Toexitoutofanyoftheaboveoptions,pressthe“MODE”button.
Auto mode:
Toaccessautomodepress“MODE”untilthedisplayshowsAuto.Pressthe“ENTER”button.
Theunitwillnowdisplay At01.Usethe“UP”and“DOWN”buttonstoselecteitherAt01orSou1.
Pressthe“ENTER” buttonagain,thiswillenableyourchosenautomode.
Toexitoutofanyoftheaboveoptions,pressthe“MODE”button.
PleaseensurethatallslaveunitsaresettothesameDMXchannelmodeasthemasterunit.
Static colour mode (to use the xture as an uplighter):
Toaccessstaticcolourmodepress“MODE”untilthedisplayshowsAuto.Pressthe“ENTER”button
andusethe“UP”and“DOWN”buttonstoselecteitherStat.Pressthe“ENTER” buttonagain,
thiswillenableyoutochoosebetweenCL01-CL15orFade.
WhenusingtheFadefunctionpressthe“ENTER” buttonandusethe“UP”and“DOWN”buttons
toselectthedesiredfadespeedbetweenSP01-SP31.Pressthe“ENTER” buttontoconrm
thesetting.
Toexitoutofanyoftheaboveoptions,pressthe“MODE”button.
Other settings:
Operating instructions
PAn (Xmotorpositive/negativemoveset) YES/NO
tilt (Ymotorpositive/invertmoveset) YES/NO
Led (digitaldisplayON/OFFset) ON/OFF
diSp (digitaldisplayinvert) YES/NO
test (functiontest)
HoUr (totalxtureruntime)
rSEt (reset)