9 / 64
2 • Unit description
80116-918
10.15
CHAPTER 2
Unit description
Unit variants
How do the unit variants differ
from one another?
There are VIO S units in different unit variants. Each unit variant has modes
assigned permanently to it.
In the VIO 300 S the unit variant 1 (= basic variant) contains all modes ap-
proved for this unit. These modes are described in the User Manual of the
unit. All other unit variants contain less modes than the basic variant. A list
of all unit variants for the VIO 300 S can be requested from Erbe Tübingen.
Currently only unit variant 1 is available in the VIO 200 S. The modes of this
variant are described in the User Manual of the unit.
How do I determine the unit
variant?
When the VIO S is switched on, the following information about the unit
software appears on the start screen:
• Software status (e.g. 2.0.x)
• Upgrades (e.g. EndoCut I)
• Unit variant (e.g. Variation 2)
The VIO 200 S is an exception. Since at the time of printing only unit variant
1 is available, no statement about the unit variant is made on the start
screen.
Which service work does the
unit variant affect?
The unit variant has an effect on the some tests of the safety check.
To Next Page
