Why are APC setup parameters invalid on my Erbe Medical Equipment?
If you encounter invalid APC setup parameters with your Erbe Medical Equipment, the solution is to analyze the CAN data, particularly looking for sector errors. Check the information provided with the equipment to assist with this analysis.
What to do if Erbe Medical Equipment shows a timeout of activation signal?
If you are experiencing a timeout of the activation signal with your Erbe Medical Equipment, ensure uninterrupted CAN transmission by checking the shielded FS cable or the position of the FS cable relative to the HF cable. If the error persists, perform a CAN analysis using a tool like PCAN explorer.
General| Type | Electrosurgical Unit |
|---|---|
| Brand | Erbe |
| Model | VIO 200 D |
| Output Power | 200 W |
| Frequency | 350 kHz |
| Footswitch | Yes |
| Modes | Cut, Coagulation |
| Mains Voltage | 100-240 V AC |
Defines safety indications like WARNING, CAUTION, ATTENTION, and IMPORTANT.
Emphasizes the importance of user manuals for servicing.
Details safety precautions related to electrical hazards and proper grounding.
Provides guidance on handling electrostatically sensitive components.
Outlines conditions that void liability and warranty rights.
Details hardware and software modifications introduced from VIO version 1.3.x.
Details hardware and software modifications introduced from VIO version 1.4.x.
Details hardware and software modifications introduced from VIO version 1.5.x.
Details hardware and software modifications introduced from VIO version 1.6.x.
Details hardware and software modifications introduced from VIO version 1.7.x.
Identifies and explains the controls located on the front panel of the unit.
Identifies and explains the controls located on the rear panel of the unit.
Details electrical specifications, power input, and operating mode parameters.
Specifies physical dimensions and environmental operating requirements.
Covers acclimatization procedures and relevant safety standards.
Provides schematic block diagrams for the VIO 300 D and VIO 200 D units.
Explains the function and details of various internal assemblies within the unit.
Introduces the two SET-UP levels and general operational aspects.
Lists and describes configurable settings available in SET-UP Level 1.
Details advanced settings available in SET-UP Level 2 for service staff.
Explains how to access and modify settings within the SET-UP menus.
Instructions on how to call up, exit, and input parameters for test programs.
Detailed explanations of various test programs, their functions, and operation.
Guidance on measuring HF power output including temperature and test setup.
Details personnel requirements, test sequences, and necessary equipment for adjustments.
Procedures for measuring voltage, spark, and current with specific test setups.
Lists error codes, their meanings, and abbreviations for identifying system modules.
Comprehensive lists of errors, their descriptions, and remedies for each module.
Lists recommended ERBE equipment for troubleshooting and maintenance tasks.
Defines who can perform service and the importance of safety checks.
Details tests for unit functions like power switch, controls, software, and activation tones.
Describes tests for monitoring critical resistance and asymmetry in circuits.
Lists spare parts for VIO D units with plug-in power supply modules.
Lists spare parts for VIO D units with screw-in power supply modules.
Provides wiring diagrams for HF generator modules and identifies circuit boards.
Details different types of receptacle modules available for the unit.
To Next Page
