ergoline ergometrics er 800S User Manual

Operation Manual
Ergometer
Type er800S
Version: 05/02 25 er800S Operation Manual
Art-Nr: 475.051
Command from Return Description
PC (ECG) from er800S
W xxx <CR> --- Desired load is set to xxx watts.
L xxx <CR> ---
Load increment is set to xxx watts
(see chapter 4, load increment algorithm).
A xxx <CR> ---
Initial load Po is set to xxx Watt
(for load value at start of ergometry).
P xxx <CR> ---
Pulse limit is set to xxx 1/min
(only required for pulse-steady-state training).
S <CR>
or --- Start ergometry with initial load Po.
s <CR>
B <CR> B xxx <CR>
Request for current load value,
return of current load value in watts.
D <CR> n xxx <CR>
Request for current RPM value,
return of current RPM value in 1/min.
H <CR> H xxx <CR>
Request for current heart rate,
return of current heart rate in 1/min.
I <CR> V.3.3 Identification of software version.
Exchange Protocol:
Remark:
W xxx <CR>
command value, e.g.load value carriage return
Appendix A: Interfaces

ergoline ergometrics er 800S Specifications

General

Brand	ergoline
Model	ergometrics er 800S
Category	Fitness Equipment
Language	English