35
3/1531-ZAP 701 14/1 Uen A 2006-10-16
AXX 9100 CONNECT R1.2 Quick Reference Guide
4. The terminal application launches.
5. Enter COM port name (e.g. com1) and select OK.
6. An AXXCLI session is invoked by typing axxcli in terminal
window. User authentication (password, 8-12 ASCII characters)
is required, as the following session start-up sequence shows.
Default password is axxcli.
>axxcli
--------------------------------------------------
AXX 9100 CONNECT Command Line Interface
--------------------------------------------------
Enter AXXCLI password: ******
AXXCLI>
7. When access has been granted, you can define the following
AXX 9100 CONNECT parameters:
IP-Configuration(Management-Port):
Show-Current-Alarms:
Change-Passwords: Manage CLI/TELNET passwords
Erase-CDB:
Reset-Device:
Display-Debug-Info:
Clear-Debug-Info:
Community-Handler:
Management-Modes:
Running-Config:
Exit:
It is sufficient to type leading characters of the command name to
avoid ambiguity – the same applies to keywords. The BACKSPACE
or DELETE key may be used to edit the command line. Commands
and keywords are not case-sensitive. The Management Port IP
address is a compulsory parameter, and must be specified by you.
All the other parameters (except default gateway) are defaulted to
pre-defined values if they are not specified.
To Next Page
Loading...