Fixing problems
24
Resetting the cordless system
In case of problems, you can try resetting the cordless system:
• Switch off the system, waiting half a minute and switch it on again.
• Or reset using CSM (if available).
After a reset, the system must function properly within 90 seconds, with no red
LEDs on.
Note
When resetting the system, all current calls will be lost.
Tip
CSM (if available) can give a detailed overview of the cordless system.
5.2 System does not function at all
1. Is the green power LED1 on the radio exchange on? (See
figure 3, page 19.)
Yes : System is powered. Try another fault area: see paragraph 5.1.
No: Continue.
2. Is the radio exchange switched on with the power switch?
Yes : Continue.
No: Switch it on.
3. Is the power cable connected properly to the mains socket and the radio
exchange?
Yes : Continue
No: Connect the power cable properly.
4. Is power present on the mains socket?
Yes : Contact your supplier.
No: Problem is in the mains.
To Next Page
Loading...