Using CSM
27
Chapter 6 Using CSM
6.1 What CSM is required for ...
Once the DCT1800-S system has been installed by your supplier, no further
actions have to be taken. It is possible to make phone calls right away.
CSM is required to:
• Replace, add and remove cordless phones: see paragraph 6.4 to 6.6.
• Change date and time on the cordless system: see paragraph 6.7.
• Investigate the cordless system in case of troubles, and generate and print
service forms: see paragraph 6.8.
• Initialise a modem for remote maintenance by a supplier: see chapter 7.
If you leave these actions to your supplier, CSM is not required.
6.2 Preparations to use CSM
1. Install the CSM software on a PC with Windows 95, Windows 98 or
Windows NT 4.0 (see the installation instructions supplied with it).
2. Connect the PC with CSM to the radio exchange with the PC cable
(RS232) that is delivered to the cordless system (see figure 5, page 28).
To Next Page
Loading...