Ericsson Dialog 4225 Vision - Send Caller Identity Code at Transfer

55Dialog 4223 Professional/Dialog 4225 Vision
During Calls
To resume the call on another extension:
z Call the extension where the call was put on hold.
CallPickUp Press (see display).
If
CallPickUp is not shown, press more... until appearing.
Notes:
You can also press
8 or On hold/Pick-up (Function key
preprogrammed by you).
If your number is multiple represented on the phone, you
can also press the key that represents your number.
Send Caller Identity Code at transfer
When transferring a call you can send the caller’s Identity Code or
number to the receiver’s display.
You have a voice connection with an external party on Line 1.
Conf/Transf Press to put the call on hold (see display).
Note: You can also press Line 2 or Inquiry.
*77* Dial.
z# Dial the caller’s Identity Code or number and press.
z Call the third party.
Transfer Press before or after answer (see display).
The ongoing call is transferred with the caller´s Identity Code or
number.
Note: You can only use this function if the receiver’s phone
is programmed to handle Identity Codes.