14
dirty battery pack contacts, an extremely hot or cold battery pack,
or a defective battery pack.
• Engagement of the UDC is not necessary for battery charge
operation, but is required to operate an M-RK Personal in the
enhanced vehicular charger. The UDC should also be in the
engaged position whenever the vehicle is moving, for both the
standard and enhanced models, to firmly hold the radio in the
charger in case of an accident.
If the Battery is deeply discharged, the radio must be
turned off when inserted into the charger.
NOTE
INSTALLATION
UNPACKING AND CHECKING THE EQUIPMENT
Before starting the installation, carefully unpack the equipment and
inspect the equipment for damage. If there is any damage, file a claim with
the carrier immediately.
Standard Charger (344A4616P1)
The following equipment is included with the Standard Charger:
• M-RK Standard Vehicular Charger 344A4616P1
• Mounting Bracket and Mounting Hardware 344A4616P11
(mounting hardware includes four machine screws, four lock
washers, six self-tapping screws and one cable tie)
Enhanced Charger (344A4616P2)
The following equipment is included with the Enhanced Charger
• M-RK Vehicular Charger 344A4616P2
• Mounting Bracket and Mounting Hardware 344A4616P11
(mounting hardware includes four machine screws, four lock
washers, six self-tapping screws and one cable tie)
To Next Page
Loading...