20
This connection wires the charger to an unswitched power source so
the charger can operate when the vehicle ignition switch is turned off.
However, if desired, the charger can be controlled by a switched power
supply.
Connecting To A Switched Power Source
If it is desired to control the charger by a switched power source by
running a lead to the ignition switch power, make the connection as
follows:
1. Using a small phillips head screwdriver, dissamble the DB-25
Power Cable connector.
2. Solder one end of a #18 AGW wire to Pin 10 of the DB-25
connector. Make sure enough lead is provided to make the
connection.
3. Reassemble the connector and plug it in the charger.
4. Route this new wire and connect the other end behind the vehicle
fuse box so that the vehicle fuse protection is used.
5. Change the charger DIP switch settings as shown under,
SETTING THE
DIP SWITCHES
to Enable Ignition A+.
The power source must have adequate current supply
capability.
NOTE
Speaker Options
The external speaker normally supplied with the charger is option
H2LS1F (19A149590P1).
Antenna Connection
The TNC connector at the back of the Vehicular Charger must be
connected to an external antenna. For optimum performance, the antenna
should be installed in accordance with the installation instructions
provided with the antenna package.
Other Connections
See the Interconnection Diagrams in the following pages for specific
details on other connections that may be required.
To Next Page
Loading...