Ericsson M-RK - Enhanced Vehicular Charger

18
DIP switch SW-3 must be configured as follows:
SW3 1234567
Standard Charger P1 OFF ON X X X X X
X = DON’T CARE
Enhanced Vehicular Charger
Ignition A+ Control:
To control the power to the charger by the ignition switch, a control
wire must be connected from the rear DB-25 connector, Pin 10 to the
ignition switch .
Connect this wire to the ignition "ON" sense point (preferably an
ACCESSORY point on the fuse panel that is switched on when the
ignition switch is in the accessory position and in the "RUN" position).
DIP switch SW-3 must be configured as follows:
SW3 1234567
Enhanced Charger P2 OFF ON X X X X X
X = DON’T CARE
DIP switch 5 (SW5-1) must also be set to OFF.
SW5
OFF
Display Invert Control:
The M-RK display may be inverted by setting the SW-3 DIP switch as
follows:
SW3 1234567
Enhanced Charger P2 X X X X OFF ON X
X = DON’T CARE
DIP switch 5 (SW5-1) must also be set to OFF.
SW5
OFF