16
MOUNTING THE UNIT
1) Select a mounting location.
2) Using the mounting bracket as a template, mark six mounting screw
hole locations on the mounting surface.
3) Using the No. 28 drill bit, drill holes into the mounting surface at the
marked locations.
4) Using the six self tapping screws, secure the mounting bracket to the
mounting surface.
5) Using the four machine screws and lock washers, secure the unit to the
mounting bracket. The charger can be fastened in any of three
different positions: parallel to the mounting surface or tilted ± 20
degrees from the parallel position. See figure 4.
Figure 4 - Mounting the Charger
SYSTEM CONFIGURATION
The Standard and Enhanced
Vehicular charger has a DIP switch bank
inside the unit. The Factory settings for the DIP switches are as follows:
SW3 1 2 3 4 5 6 7
Standard Charger P1 ON OFF ON OFF OFF OFF OFF
Enhanced Charger P2 ON OFF ON ON ON OFF OFF
To Next Page
Loading...