EasyManua.ls Logo

Ericsson RBS 2106 - Page 234

Ericsson RBS 2106
487 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Common Control Channel Handling
The CCCH queue system is used for system information 7, 8, 13,
16 and 17 for transmisstion on BCCH extended.
IMMEDIATE_ASSIGNMENT messages:
The queues are handled in a FIFO (First-In-First-Out) manner when the
following messages are composed:
IMMEDIATE_ASSIGNMENT
IMMEDIATE_ASSIGNMENT_EXTENDED (first IA)
IMMEDIATE_ASSIGNMENT_REJECT (first IAR)
PAGING_REQUEST messages:
The queues are handled in a FIFO manner when the first IMSI or TMSI
intended for a PAGING REQUEST message is dequeued.
Packing of Messages
IMMEDIATE_ASSIGNMENT messages:
If possible, two IAs (queued or stored for retransmission) will be
packed into one IMMEDIATE_ASSIGNMENT_EXTENDED message.
If Extended paging is used, IAs originating from two different paging
groups may be packed into the same
IMMEDIATE_ASSIGNMENT_EXTENDED message.
A maximum of four unique IARs can be packed into one
IMMEDIATE_ASSIGNMENT_REJECT message.
If Extended paging is used, IARs originating from different paging
groups may be packed into the same
IMMEDIATE_ASSIGNMENT_REJECT message.
PAGING_REQUEST messages:
As many IMSIs and TMSIs as possible (for a certain paging group) will
be packed into one PAGING_REQUEST message (type 1, 2 or 3). If
Extended paging is used (see section Selection of Page Mode below),
IMSIs and TMSIs originating from two different paging groups may be
packed into the same PAGING_REQUEST message.
IMSIs and TMSIs stored for retransmission (in the corresponding
paging stack) are included in the PAGING_REQUEST message if not
enough IMSIs or TMSIs are found in the actual paging queue.
Selection of Page Mode
The RBS selects the appropriate Page mode value /GSM:04.08:-
10.5.2.26./ for each message. The following Page modes are used:
Normal
Extended
Paging reorganization
The allowed use of extended page mode is configured (as a percentage)
on command from the BSC. This is done by means of configuration
parameter DRX_DEV_MAX, see section Administration below.
232 (485)
EN/LZT 720 0008 P2A
2001-11-28
© Ericsson Radio Systems AB
All Rights Reserved
Preliminary

Table of Contents

Other manuals for Ericsson RBS 2106

Related product manuals