4. SER MENU (SER2, SER3)
To change the RS-232 related parameters, use the SEr menu; Use the SEr2 menu to change the USB
related parameters . See b3-serial_communication.pdf for detailed information .
Press key to enter the SEr menu. (also applies to SEr2 and SEr3)
F 0
Select the serial port function and press key.
0 Continuous output
1 Send by key or command
tYPE 0
Choose the data format and press key.
bAud
9600
Select the baud rate and press key.
Prot.
8-n-1
Select the protocol and press key.
8-n-1 8 bits, No Parity, 1 stop bit
8-E-1 8 bits, Even parity, 1 stop bit
8-o-1 8 bits, Odd parity, 1 stop bit
rtS 0
Select hardware flow control and press key.
0 Hardware flow control off
1 Hardware flow control on
SPd 0
Select the data transmission rate and press key.
0 Indicator rate (6.25/second by default)
1 1/second
... 5 5/second
11
To Next Page
Loading...