1. MATTERS TO CONSIDER
● The device must be operated from an earthed socket.
● It should not be connected to the same power line with powerful electrical
machines and should not be operated near
● Make sure that the electrical connection is cut before the cover of the
device is disassembled.
● Recommended cable thickness for load cell connection is 1 mm². If it is
necessary to use thinner cable, it should be thickened by using double (or
more) ends for ±supply. This is especially important for long cable
connections.
● If the load cell/collection box connection does not have sensing leads (4-
way connection) device will give Error 3. In such cases, connect the
sensing leads to the supply terminals at the closest point to the load cell.
(See wiring diagram.)
● Shielded and twisted-pair cable for load cell and communication
connections should be used.
● For the most accurate weighing results, the device should be left in
operation for at least half an hour before calibration.
2
To Next Page
Loading...