Page 26
Notice G05 - 3 590 503
Issue: 11/2011 - Rev.A
ERVOR (SCA) - 6, Rue Désiré Granet - Z.I. du Val d'Argent - 95100 ARGENTEUIL FRANCE
(33) 01 34 11 50 00 (33) 01 34 11 50 10
Web : www.ervor.com - Email : info@ervor.com
11 - MAINTENANCE INSTRUCTIONS
BEFORE ANY MAINTENANCE OPERATION ALL INSTRUCTIONS
DESCRIBED BELOW MUST BE FOLLOWED CAREFULLY.
11 - A - COMPRESSOR LUBRICATION
Lubrication of the G05 compressor is done by oil splashing which givesthe following advantage.
- Dispersion of oil throughout the entire compressor and avoidance of damage due to leaks
or clogging of the oil pipe.
However, it is absolutely necessary :
- to maintain the oil level in the casing above the minimum level
- that the compressor runs over its minimum speed of 600 T/min.
- to respect the indicated direction of rotation (see chapter "sense of rotation")
!
Minimum
Maximum
OIL PIPE
Oil plug
+ gasket
Oil drain
Oil sight glass
To Next Page
Loading...
